What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
08.06.2025 23:34
These are simplified answers to the original question, and does not change anything I wrote above.
[image of Common-mode choke]
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
One is “what exactly is in a ‘surge protector’ ? ”
but this device (an Inductor) … impedes the rapid changes in the current.
There are two important concepts here.
England is launching a gonorrhea vaccine. Is Canada next? - Yahoo
This is where this question deviates from being a 'generic' question, and becomes more specific.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Here is a simplified AC power diagram.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Hallucinogens Linked to Milder PTSD - Neuroscience News
[old diagram got deleted by accident]
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
nine
My Husband Drinks a Pot of Coffee a Day—So I Asked the Experts If That's Safe - EatingWell
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
The MOV will conduct when the voltage exceeds 50% of line voltage.
What is lightning?
DePaul soccer player Chase Stegall dies in residence hall - Chicago Sun-Times
Now when you have a certain ac resistance, then a current flows in a loop.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
But it can get overloaded, and no longer works.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
At least they know the answer if they wanted it.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
NZ nutritional biochemist takes her supplement breakthrough to the market - Stuff
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Can the fuse protect the electronic devices from lightning instead of a surge protector.
What should a young woman do to control sagging breasts?
He then describes the function of a fuse.
This one hit behind the barn.
This is 'the assistant's answer'
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
What does a fuse do?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
For this case there are devices called Metal oxide varistors (MOV).
These devices are installed between the “hot” and “neutral” and protective ground.
so, what happens?
The third is lightning and “how it gets conducted into a home.”
A fuse is a non-resetable over current circuit protector.
This is where the MOV conducts again, and dissipated the energy.
Trump puts U.S. Steel cart before the horse - Axios
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
eight
Barnstars:
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
At one ohm, the resistor has a maximum of 1 watt power.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
a photo is worth a thousand words.
(Dc diagram shown, AC is similar).
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
It also is a device that limits the change in current flow.
A circuit breaker is similar, but is resettable.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Upvotes:
I post the exact comment here.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–10–10[John johnson John Johnson ]
So, the voltage could go up to 500 volts, and the fuse will not open up.
There are three different concepts here that are getting confused.
He then asserts :
Because the load is inductive, the current lags the voltage.(by a bit).
This device then solves the entire problem.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
The other is “what does a “fuse” do?”
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
2024–10–14 [Omar Gharbi Omar Gharbi ]
In schematic diagrams this is the symbol for a fuse:
It seems Mohan does not understand the difference between a comment and an Answer.
The bolt then partially travels down the line to your home.
One
But… the neutral is now “floating” because of the 1 ohm resistance.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
but I think this circuit , shows a few more pieces.
An AC voltage/ current source, and an ac inductive load.
the problem then depends on "how fast does the fuse operate?".
what exactly is a ‘surge’ protector?
2024–10–16 [ OO OLAOYE OYEBODE ]
First Sentence:
Edit 2024–10.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
He then describes Rainy Season and Lightning.